Exam CISCO-350-024 Demo000-733

1.Consider phones A and B. Both phones are registered in the same cluster. Phone A is configured with extension 1000. Phone B is configured with extension 2000. Indicate what choice below is necessary and sufficient to allow phone A to be able to call phone B AND phone B to be able to call phone A050-694.

A: Both phone extensions are in the same partition
B: Both phones are assigned the same Calling Search Space
C: Both (A) and (B)
D: None of the above
Correct Answers:  D70-536

2.What is RPF?HP0-075

A: Reverse Path Forwarding
B: Reverse Path Flooding
C: Router Protocol Filter
D: Routing Protocol File
E: None of the above
Correct Answers:  A10g DBA

3.In an IP Contact Center deployment, the Erlang-C Traffic Model is used to provision:HP0-075

A: Agents receiving/handling inbound calls
B: Ports on a voice gateway interfacing to the PSTN
C: Ports on an IP-IVR interfacing with Cisco CallManager
D: Agents initiating/handling outbound calls only
Correct Answers:  A050-692

4.Look at the router configuration above. If this router has a configuration-register setting of 0x102, select the proper boot sequenceHP0-753:
 
A: The router will try to use the image "rsp-isv-mz.112-8.P" on slot 0, then attempt to boot from a network server, and finally boot from ROM.
B: The router will try use the image "rsp-isv-mz.112-8.P" on slot 0, then attempt to boot from any other valid image in flash, and finally boot from ROM.
C: The router will try to use the image "rsp-isv-mz.112-8.P" on slot 0, and then it will boot from ROM.
D: The router will try to use the image "rsp-isv-mz.112-8.P" on slot 0, and then attempt to boot from a network server.
Correct Answers:  AHP0-764

5.What protocol does an IP Phone use to learn the IP Address of its TFTP Server?MB3-006

A: HSRP
B: DHCP
C: Skinny Station Protocol
D: STP
E: CDP
Correct Answers:  B000-873

6.In an IP Contact Center deployment, the Erlang-B Traffic Model is used to provision the following resources:mb2-421

A: Agents receiving/handling inbound calls
B: Ports on a voice gateway interfacing to the PSTN
C: Ports on an IP-IVR interfacing with Cisco CallManager
D: B and C
E: None of the above
Correct Answers:  D000-705

7.A new Cisco router has no configuration defined. Which methods can be used to configure the router for the first time? (multiple answer)000-636

A:Using SNMP via a network management station
B:Connecting a terminal to the console port and running the Setup dialogue
C:Connecting a terminal to the console port and directly typing in configuration commands
D:Using BOOTP/SLARP/RARP to download a configuration file that has been created ahead of time
E:Connecting a terminal to the console port, defining a minimal configuration, connecting the router to the network, and using TFTP to download a configuration file that has been created ahead of time
Correct Answers:  B, C, D, E000-867

8.When dimensioning call center agents receive calls from infinite sources (PSTN callers) where calls are queued during the busy hour, the traffic model typically used is:920-250

A: Extended Erlang-B
B: Engset
C: Erlang-C
D: Binomial
E: None of the above
Correct Answers:  C310-560

9.With CGMP enabled, which are unique about the following MAC address range: 01-00-5E-00-00-00 to 01-00-5E-00-00-FF? (multiple answer)642-091

A:CGMP does not prune those MAC addresses.
B:They contain the CGMP Multicast addresses for the IGMP Leaves and IGMP Queries.
C:CGMP filters those MAC addresses when they arrive at the processor
D:They are the reserved IP addresses of 224.0.0.0 to 224.0.0.255 for forwarding local IP multicast traffic in a single Layer 3 hop.
Correct Answers:  A, B, D70-218

10.If a 7960 IP Phone sends voice media frames towards the access switch, how will these frames be observed at point A NOTE: Assume that a frame sniffer capturing data between the phone and the access switchNOTE: Assume the phone is connected into port FastEthernet0/1.70-220
 
A: The frame will be tagged with a 802.1Q VLAN ID of 12, and will have an 802.1p cos value of 3.
B: The frame will be tagged with a 802.1Q VLAN ID of 112, and will have an 802.1p cos value of 5.
C: The frame will be tagged with a 802.1Q VLAN ID of 0, and will have an 802.1p cos value of 3.
D: The frame will be un-tagged.
Correct Answers:  B70-237
 本文出自 51CTO.COM技术博客